Want to open a good excavator, these four operation tips you have to know!

[BONOVO]

Driving an excavator is a technical job, it is not difficult to learn how to operate, but if you want to do beautiful work, you must have several years of experience. In response to the common problems in the operation of excavator, an old master with 10 years of driving experience shared his valuable experience in exchange for sweat.

1 Small excavator how to climb the flat car (no ladder)

The flat car without a ladder on the small excavatoris very easy to tilt, resulting in more and more distortion when backing up behind. In fact, this problem is easy to solve: adjust the excavatorAngle when getting on the car to ensure that the chain plate and the plate car are aligned; Then turn the excavatorstraight (one side of the cab excavator chain plate is vertical), support it with the excavator arm, and the excavator slowly climbs up. This process must be slow, while observing the adjustment while reversing, the faster the speed, the easier it is to run off.

2 How to dig a T-trench

The so-called T-shaped trench is to dig the trench to the wall, which is more difficult to dig. It is better to start digging from the end of the T word in contact with the wall, and don't panic when you encounter this kind of thing, because in addition to riding on the trench, everyone will dig wide.

If you encounter sandy soil, it is not recommended to ride on the ditch to dig, which is easy to happen dangerous. If the soil quality is relatively good to ride the trench digging, it is necessary to note that: when digging, do not use the forearm to collect the soil forcefully, which will cause the excavator to offset; To dig with a bucket, try to dig out the trench shape at a time.

3 How to Level the ground

About leveling, this is the driver's most basic operating skill. Leveling is not a set of theories you can master, it takes a lot of practice.

Let me tell you a little tip: When leveling, move slowly, dig as slowly as you can, dig as long as you can, and then use the tip of the shovel to slowly scrape through the soil.

So how to see the level? When it feels high, slowly scrape a little, and when it feels low, push a little dirt with the tip of the bucket. Step by step, you will eventually acquire a reasonable and even perspective.

It should be noted that the excavatormust be stopped and levelled, if it is working on the mound, you need to move the excavatorleft and right so that the bucket is parallel to the ground.

4 How to load the car quickly

I load it too slowly. How can I load it fast? Many friends have encountered this problem, here are some tips.

The first is that the excavator should stop smoothly, so that it is fast and smooth when turning.

The second is to minimize the movement, can reduce one is one. When digging the soil, the bottom of the bucket should be parallel to the soil layer as far as possible, and then the forearm can shovel the soil, and this action can dig more and more full. When dumping soil on the car, try to lift the upper arm and dump the soil over the bucket, do not push the lower arm, because the soil piled on the bucket will fall off in advance.

Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

for more info just visit our website at www.bonovogroup.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com