How to extend the service life of slip loader hydraulic cylinder?
Posted: Oct 27th, '24, 23:37
Due to the failure of the hydraulic cylinder, the phenomenon of sliding loader shutdown is not uncommon, then how to make the hydraulic cylinder do not fail? How about extending the life of the hydraulic cylinder? Hydraulic cylinder maintenance has 7 points:
1. The hydraulic oil should be replaced regularly during the use of the cylinder to keep the hydraulic oil clean. Dirt in the oil can damage the components of the system.
2, maintain the hydraulic oil volume. Less oil will bring in air, making the hydraulic system run abnormally.
3, pay attention to observe whether the oil cylinder oil leakage. The leak indicates that the seal is broken, and it is not replaced in time, which not only consumes oil, but also reduces the output, and does not act when it is serious.
4, often check the thread, bolt and other connection parts, to maintain its effective tight state.
5, the cylinder in each use, to full stretch full contraction test run 5 strokes and then run with load. This can exhaust the air in the system, preheat the system, and effectively avoid the presence of air or water in the hydraulic system.
6, control the system temperature, the oil temperature is too high will reduce the service life of the seal, long-term high oil temperature makes the seal permanent deformation, or even complete failure.
7, protect the outer surface of the piston rod, prevent the damage of bumps and scratches to the seals, and often clean the dust ring parts of the cylinder dynamic seal and the sand on the exposed piston rod.
In summary, it is recommended that everyone pay attention to the above seven points in daily use, which can greatly reduce the failure rate of hydraulic cylinder and extend the service life!
Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!
for more info just visit our website at www.dig-dog.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com
1. The hydraulic oil should be replaced regularly during the use of the cylinder to keep the hydraulic oil clean. Dirt in the oil can damage the components of the system.
2, maintain the hydraulic oil volume. Less oil will bring in air, making the hydraulic system run abnormally.
3, pay attention to observe whether the oil cylinder oil leakage. The leak indicates that the seal is broken, and it is not replaced in time, which not only consumes oil, but also reduces the output, and does not act when it is serious.
4, often check the thread, bolt and other connection parts, to maintain its effective tight state.
5, the cylinder in each use, to full stretch full contraction test run 5 strokes and then run with load. This can exhaust the air in the system, preheat the system, and effectively avoid the presence of air or water in the hydraulic system.
6, control the system temperature, the oil temperature is too high will reduce the service life of the seal, long-term high oil temperature makes the seal permanent deformation, or even complete failure.
7, protect the outer surface of the piston rod, prevent the damage of bumps and scratches to the seals, and often clean the dust ring parts of the cylinder dynamic seal and the sand on the exposed piston rod.
In summary, it is recommended that everyone pay attention to the above seven points in daily use, which can greatly reduce the failure rate of hydraulic cylinder and extend the service life!
Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!
for more info just visit our website at www.dig-dog.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com