Knowledge of liquid maintenance for mini tailless excavators

[BONOVO]

Knowledge of fluid maintenance for subminiature excavator

First, grease

(1) Grease is used to avoid deformation and noise at the joint.

(2) After a long time of use, any parts may look insensitive or noisy, should be added grease.

(3) Wipe away the old grease kneaded when filling the grease.

(4) Pay attention to the eradication of old grease. Dust will stick to the grease and cause the rotating parts to wear out.

Knowledge of fluid maintenance for subminiature excavator

Ii. Lubricating oil

(1) When selecting the oil, it should conform to the grade and temperature in the application of the small excavator. Change the oil even if it is not dirty within the specified time.

(2) Be careful to avoid some impurities and dust into the lubricant. Most of the problems with the machine are caused by the intrusion of impurities.

(3) According to the regular amount of oil refueling, small excavatorhave some obvious abnormal problems, too much oil or too little oil will lead to shortcomings.

(4) Do not mix different grades or grades of lubricant.

(5) When replacing the oil, it is necessary to replace the relevant filter element, especially when replacing the oil core. Before installation, a small excavatoradds fresh, clean and gentle oil to the new filter element.

Iii. Fuel

(1) When storing or adding fuel, special care should be taken not to allow impurities to enter.

(2) When selecting oil, it is necessary to select the specified fuel according to the environment and temperature and select the right oil.

(3) In order to avoid condensation of moisture in the air and formation of water in the fuel tank, the water tank should be filled after daily operation.

Knowledge of fluid maintenance for subminiature excavator

(4) Before launching the starter or 10 minutes after participating in the fuel, the sediment and water are discharged from the container.

(5) Assuming that the initiator runs out of fuel or replaces the filter element, it is necessary to eradicate the air in the oil circuit.

Fourth, coolant

(1) It is necessary to use antifreeze under any climatic conditions.

(2) Check the coolant level according to the rules, and refuel when lacking. Lack of coolant can cause the engine to overheat.

(3) According to the environment and temperature, equipped with a suitable mixing ratio of coolant and antifreeze.

Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

for more info just visit our website at www.bonovogroup.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com