Do you know how to choose small loader tires?
Posted: Nov 10th, '24, 21:00
As an important part of a small loader, the use of tires is closely related to the performance and working capacity of the loader. Therefore, in the use of small loader tires must pay attention to the relevant matters, so as not to cause tire damage, resulting in the loadercan not work normally. The tire standard specifies the greater load at a given speed at the corresponding tire pressure. The tire pressure of the loaderrecommended by the manufacturer is determined according to the national standard requirements in the rated load of the vehicle and the load borne during normal operation. Therefore, the vehicle must be loaded according to the rated load calibrated by the loader, and it is acceptable to overload within 15% under normal circumstances. However, overloading will increase tire deformation and seriously affect the service life of tires. Under special circumstances, if overload is necessary, the cold pressure of the tire should be appropriately increased, but it should not be used for a long time.
At present, most of the domestic small loaderuse low pressure wide base bias tires, and the allowable radial deformation is 3% to 4%. In the actual operation process, attention should be paid to the radial deformation of the tire, so that its deformation should not exceed this range. Similarly, driving speed also has a great impact on the service life of the tire. In practical use, speed and load have the same meaning, and in some cases, speed is more important. In order to achieve better use results, if the speed is higher than the rated speed of the tire, the transport load should be appropriately reduced; If the speed is lower than the rated speed of the tire, the transport load can be appropriately increased. Due to tire contact with the ground in actual use, friction, body vibration, circumferential and lateral deformation, with the increase of speed, tire temperature will rise sharply, resulting in tire explosion.
During the operation of the small loader, the load acting on the tire changes periodically, resulting in periodic deformation of the tire and contact friction between the tire and the ground. When driving in summer, the tire temperature range is limited to 100 ° C ~107 ° C, if more than 115 ° C is the dangerous temperature, it will produce a burst tire. Therefore, in the hot season, the method of morning and evening work and noon rest is used to prevent excessive tire temperature. If the situation does not allow, during the operation, be sure to check the tire temperature, touch the tire body with your hand, and stop the car immediately if it is hot. When parking to rest, the car should be parked in the shade, avoid the sun tire, and then operate after the tire temperature drops naturally. Do not pour cold water or deflate to reduce pressure and cool down.
Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!
for more info just visit our website at www.bonovogroup.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com
At present, most of the domestic small loaderuse low pressure wide base bias tires, and the allowable radial deformation is 3% to 4%. In the actual operation process, attention should be paid to the radial deformation of the tire, so that its deformation should not exceed this range. Similarly, driving speed also has a great impact on the service life of the tire. In practical use, speed and load have the same meaning, and in some cases, speed is more important. In order to achieve better use results, if the speed is higher than the rated speed of the tire, the transport load should be appropriately reduced; If the speed is lower than the rated speed of the tire, the transport load can be appropriately increased. Due to tire contact with the ground in actual use, friction, body vibration, circumferential and lateral deformation, with the increase of speed, tire temperature will rise sharply, resulting in tire explosion.
During the operation of the small loader, the load acting on the tire changes periodically, resulting in periodic deformation of the tire and contact friction between the tire and the ground. When driving in summer, the tire temperature range is limited to 100 ° C ~107 ° C, if more than 115 ° C is the dangerous temperature, it will produce a burst tire. Therefore, in the hot season, the method of morning and evening work and noon rest is used to prevent excessive tire temperature. If the situation does not allow, during the operation, be sure to check the tire temperature, touch the tire body with your hand, and stop the car immediately if it is hot. When parking to rest, the car should be parked in the shade, avoid the sun tire, and then operate after the tire temperature drops naturally. Do not pour cold water or deflate to reduce pressure and cool down.
Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!
for more info just visit our website at www.bonovogroup.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com