How to clean the excavator water tank?

[DIG-DOG]

The excavatorhas been used for a long time, and the water tank of the excavator also needs to be cleaned. As a hydraulic excavatormanufacturer, let's take you to understand how to clean the excavatorwater tank!

First, drain the coolant from the radiator and engine block, then close the drain plug and add tap water and detergent to the radiator.

Second, start the excavatorengine and run at a speed slightly higher than the low speed idling, when the thermometer pointer to the green area, continue to run the engine for about ten minutes.

Turn off the engine and open the drain plug, and flush the cooling system with running water until clean water is discharged.

In addition, it should be noted that for the equipment with too high water temperature causing the boiling phenomenon, after the completion of the water tank cleaning, the equipment still has a high water temperature phenomenon, and the fans can also be investigated from the following aspects: Re-check the filter on the side of the radiator of the excavator. Because the working environment of the excavatoris different, there may be dust or catkins adsorbed on the filter of the radiator, which will cause the water temperature of the excavator to rise and the phenomenon of boiling.

Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

for more info just visit our website at www.dig-dog.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com