Mini excavator fuel saving tips

[DIG-DOG]

It is known that in addition to the maintenance of the machine, the daily operating cost accounts for most of the oil, and every time the machine is refueled, will it faint and hurt? Due to the inevitable need for refueling, it is necessary to work hard from fuel saving (today to some hard plates) to provide you with fuel-saving techniques for excavatoroperation.

Before sharing, think of yourself as a digger and you'll better understand why.

1, when loading, the excavatorshould be located at a higher position, and the truck should be parked at the same height as the working table.

The reason is simple, a rock, you lift your knees as hard as your head? How much "energy" will it save? Assuming the same height as in the early years, the power can be trekked by 40%.

2, when the bucket cylinder and the connecting rod, the ejector rod cylinder and the ejector rod are 90°, each cylinder pushes the excavator with the maximum force.

3, when excavatorthe natural ground, the bucket or release equipment should adhere to the ground Angle of about 30°, and then withdraw the bucket rod. When the bucket rod is close to the vertical, the bucket rod has the greatest force and can withstand a greater load.

These two key points are like bending the arm to carry something, still insist on the arm straight, of course, bend.

4, at the beginning of excavator, do not extend the bucket rod out of the maximum action plan, the best action plan is about 80%.

5, bucket shaft excavatorplanning: bucket shaft from the furthest 45° to the inner Angle of 30°.

excavatordepths vary slightly, but larger buckets and buckets should be operated within this plan and not at the end of the cylinder stroke.

6, in the continuous excavatorprocess, the chassis is placed forward so that it can walk immediately after the excavation. If you want to walk, please change again, you will burn a lot of oil at the beginning and the end.

7, when digging the trench, first dig the two ends of the trench, and then dig the center part. In this way, excavatorin the center can save a lot of work and effort.

8. Put the engine in economic gear. Select Auto idling to allow the engine to spin while exploring space.

9. Minimize the radius of rotation.

10, the smaller the excavatordepth, the better the excavatoreconomy.

The excavation is divided into three layers: upper, middle and lower. Assuming that the excavation is carried out from low to high in sequence, the main reason is that the action plan increases, and then the operation power is reduced due to the increase of the power plan of the excavator, which will cost a lot of oil.

Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

for more info just visit our website at www.dig-dog.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com