How can small excavators be more fuel efficient
Posted: Dec 18th, '24, 21:13
Discussing how [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] can be more fuel efficient has always been a problem that can not be ignored. Xiaobian has sorted out many methods, and now it is time to take a look at the system.
For [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url], reducing fuel consumption has always been a problem. Want to improve the efficiency of the equipment, but do not want to spend too much money on oil. Below, Xiaobian has written some tips on the fuel saving of small excavators, and I hope the following content can help you.
Specific measures:
First, adhere to the temperature of the normal operation of the engine, especially in the cold season, try to adhere to the water temperature of 75-90°C and use oil according to the season.
Secondly, regular removal of scale in the cooling system, pipe and silencer grease and sediment.
Third, adjust the brakes correctly and often look at the front and rear wheels of the tractor to maintain normal tire pressure.
Fourth, adhere to the electrical system and starting organization function intact. Do not put the [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] engine on hold for a long time and stop it immediately.
Fifth, the locomotive load is appropriate. Practice has proved that the load is about 85%, the most fuel efficient and the most economical.
Sixth, pick the right speed. Use "advanced small throttle" in light load.
Seventh, reasonable selection of [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] and continuous operation. Correct planning of driving roads, as far as possible to reduce idle speed, no-load, roundabout, half-way stay, shorten the total interval of travel, reduce inefficient energy consumption.
Eighth, the timely and reasonable protection of skills, so that all components and organizations adhere to outstanding skill status.
Ninth, clean oil, metering and refueling. If not pre-deposited and filtered before use, impurities in the oil will cause damage to the plunger and needle valve, resulting in reduced locomotive power and increased fuel consumption. Therefore, the general oil should be deposited for more than 48 hours before use.
No. 10: Avoid oil spills. Because of the long-term use of [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url], poor touch parts, improper installation, mat damage, screw loosening, pipeline deformation or cracking, aging seals will lead to oil leakage. Therefore, it is necessary to adopt corresponding countermeasures to stop fuel economy in time.
The above is a way to save fuel for everyone in the [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] When operating the roller, according to the above method, it can save fuel. Similarly, if you have any good ideas, you can also consult us.
How to better complete the operation of the small excavator, the first thing is to use the oil that fits the type of machine, not only to do a good job of protection and maintenance operations, but also to use the mechanical rate rationally, so that it can be more fuel efficient.
Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!
for more info just visit our website at www.bonovogroup.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com
For [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url], reducing fuel consumption has always been a problem. Want to improve the efficiency of the equipment, but do not want to spend too much money on oil. Below, Xiaobian has written some tips on the fuel saving of small excavators, and I hope the following content can help you.
Specific measures:
First, adhere to the temperature of the normal operation of the engine, especially in the cold season, try to adhere to the water temperature of 75-90°C and use oil according to the season.
Secondly, regular removal of scale in the cooling system, pipe and silencer grease and sediment.
Third, adjust the brakes correctly and often look at the front and rear wheels of the tractor to maintain normal tire pressure.
Fourth, adhere to the electrical system and starting organization function intact. Do not put the [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] engine on hold for a long time and stop it immediately.
Fifth, the locomotive load is appropriate. Practice has proved that the load is about 85%, the most fuel efficient and the most economical.
Sixth, pick the right speed. Use "advanced small throttle" in light load.
Seventh, reasonable selection of [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] and continuous operation. Correct planning of driving roads, as far as possible to reduce idle speed, no-load, roundabout, half-way stay, shorten the total interval of travel, reduce inefficient energy consumption.
Eighth, the timely and reasonable protection of skills, so that all components and organizations adhere to outstanding skill status.
Ninth, clean oil, metering and refueling. If not pre-deposited and filtered before use, impurities in the oil will cause damage to the plunger and needle valve, resulting in reduced locomotive power and increased fuel consumption. Therefore, the general oil should be deposited for more than 48 hours before use.
No. 10: Avoid oil spills. Because of the long-term use of [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url], poor touch parts, improper installation, mat damage, screw loosening, pipeline deformation or cracking, aging seals will lead to oil leakage. Therefore, it is necessary to adopt corresponding countermeasures to stop fuel economy in time.
The above is a way to save fuel for everyone in the [url=ttps://www.bonovogroup.com/construction-machinery]small excavators[/url] When operating the roller, according to the above method, it can save fuel. Similarly, if you have any good ideas, you can also consult us.
How to better complete the operation of the small excavator, the first thing is to use the oil that fits the type of machine, not only to do a good job of protection and maintenance operations, but also to use the mechanical rate rationally, so that it can be more fuel efficient.
Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!
for more info just visit our website at www.bonovogroup.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com