How to save fuel on small excavators

[DIG-DOG]

For small excavators, reducing fuel consumption has always been a difficult problem. I want to improve the operating efficiency of the equipment, but I don't want to spend too much money on oil. Below, the editor has compiled some tips on fuel saving for small excavators, hoping that the following content can help you.

Specific methods:

First, maintain the temperature of the engine during normal operation, especially in cold seasons, try to keep the water temperature at 75-90°C and use oil according to the season.

Second, regularly remove scale in the cooling system, grease and sediment in the pipes and mufflers.

Third, adjust the brakes correctly and check the front and rear wheels of the tractor frequently to keep the tire pressure normal.

Fourth, keep the electrical system and starting mechanism functioning properly. Do not leave the small excavator engine idle for a long time, and stop immediately.

Small excavator

Fifth, the locomotive load is appropriate. Practice has shown that the load is about 85%, which is the most fuel-efficient and economical.

Sixth, choose a truly appropriate travel speed. Use "high-level small throttle" for medium and light loads.

Seventh, choose small excavators reasonably and work continuously. Correctly plan the driving route, try to reduce idling, no-load, roundabouts, halfway stops, shorten the total travel distance, and reduce inefficient energy consumption.

Eighth, timely and reasonably carry out technical maintenance to keep all components and organizations in good technical condition.

Ninth, clean the oil, meter and refuel. If it is not pre-sedimented and filtered before use, impurities in the oil will cause damage to the plunger and needle valve, resulting in reduced locomotive power and increased fuel consumption. Therefore, general oil should be deposited for more than 48 hours before use.

Tenth, avoid oil leakage. Due to long-term use of small excavators, poor contact of contact parts, improper installation, damaged pads, loose screws, deformation or cracking of pipes, and aging of sealing rings will cause oil leakage. Therefore, it is necessary to take corresponding countermeasures to stop fuel economy in time.

The above is a way to save fuel for everyone with a small excavator. When operating a road roller, according to the above method, it can save fuel. Similarly, if you have any good ideas, you can also consult us.

How to better complete the work of the small excavator? First of all, you need to use oil that suits the type of machine. You must do a good job of maintenance and care, and use the mechanical rate reasonably, so that you can save more fuel.

Buy a small excavator, buy a second-hand small excavator, buy excavator parts, sell excavator parts, buy a small excavator

Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

for more info just visit our website at www.dig-dog.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com