Excavator attachment manufacturers reveal the correct process for cleaning excavators

[BONOVO]

In the daily maintenance of excavators, cleaning is a vital task. The correct cleaning process can not only keep the appearance of the excavator clean, but also extend its service life and ensure efficient operation. Next, let the excavator attachment manufacturer reveal the correct process of cleaning the excavator in detail, and insert some relevant long-tail keywords, such as "", to help you better understand and operate.

Preparation

Before you start cleaning the excavator, you must be fully prepared. First, prepare suitable cleaning tools, such as "high-pressure water guns", which can efficiently wash away stubborn dirt on the surface of the excavator; there are also brushes of different materials, such as "nylon brushes" for cleaning more delicate parts to avoid scratches. In addition, prepare a special "excavator cleaning agent", which has a good cleaning effect on various oil stains and mud stains attached to the excavator after operation. At the same time, in order to ensure safety, wear protective equipment, such as gloves, goggles, etc.

External cleaning

Start cleaning from the outside of the excavator. Use a "high-pressure water gun" to wash the body with appropriate water pressure, starting from the top and gradually going down, focusing on the "chassis parts", "tracks" and body side panels where mud and dust easily accumulate. For some tightly attached mud blocks, you can first use a brush with a cleaning agent to brush them, and then use a high-pressure water gun to wash them. When cleaning the "cab glass", pay special attention to adjusting the water pressure of the water gun to avoid excessive water pressure from damaging the glass. During the cleaning process, pay attention to the various gaps in the body to ensure that all dirt is removed.

Attachment cleaning

Excavator attachments, such as "buckets" and "breakers", are more critical to clean because they are in direct contact with the operating materials. For the bucket, first clean the residual materials inside, and then use a high-pressure water gun and a brush to carefully clean the bucket teeth, bucket walls and other parts. For the "breaker", because of its complex structure, be careful not to let water enter the key hydraulic components when cleaning. You can first wipe the surface with a damp cloth, then use a small amount of cleaning agent to clean the oily areas, and finally wipe it dry with a dry cloth.

Internal cleaning

After completing the external and attachment cleaning, proceed to internal cleaning. Open the "engine hood" and use compressed air to blow off the dust on the surface first, then wipe the engine housing, filter and other parts with a soft cloth dipped in detergent. Note that you cannot directly rinse the engine compartment with water to prevent short circuits. For the cab, use a vacuum cleaner to suck away dust and debris, and then wipe the seat, dashboard, operating lever and other parts with a damp cloth to keep the cab clean and tidy.

Drying treatment

After cleaning, be sure to dry it thoroughly. Let the excavator dry naturally in a well-ventilated place, or wipe and blow dry the remaining moisture with a clean towel, compressed air, etc. Especially for parts that are prone to rust, such as "tracks" and "chassis", make sure they are completely dry to avoid rust and corrosion due to residual moisture.

Cleaning the excavator according to the correct process revealed by the excavator attachment manufacturer above can keep your excavator in the best condition at all times and provide strong guarantees for efficient operation.