Small excavator caught fire

[DIG-DOG]

Experts say that under normal circumstances, small excavatorproducts will not cause the normal repair of fire. In special cases, long-term neglect, maintenance and repair are not timely. Driver misconduct, unauthorized electrical system corrections, arson and other causes are the main causes of "spontaneous" or other fire incidents.

According to the statistics of the insurance company, the fire incidents of small excavatormostly occur near the diesel fuel tank or engine, as well as the oil pipe leakage caused by fire, improper conversion of the electrical system, and short circuit. There is a high percentage of misused fuses. Although the possibility is very small, if it happens, the economic loss of more than $1 million worth of micro excavatorequipment is large.

Therefore, regarding this kind of fire incident, prevention and prevention is particularly important. Experts suggest that the better way to prevent spontaneous combustion of small excavatoris to check and maintain small excavators on time to prevent such problems. First check the engine, hydraulic and electrical systems for leaks or aging. Clean the engine system in time to ensure that the engine is inside. In addition, it is necessary to strengthen self-service operators. Many small excavatorare not equipped with fire extinguishers. In the event of an incident, the operator is unable to save lives. Equipped with fire fighting equipment such as dry powder fire extinguishers, an annual inspection is conducted at the local fire equipment store.

When going uphill, please note:

1. Check the slope Angle to see if it is within the function range of the excavator. If the slope is too steep, rock the material from the upper part of the slope to the lower part to reduce the slope.

2. Remove large rocks. When climbing on steep slopes, rocks can also cause the tracks to slide, which then causes the excavators to move forward.

3. When climbing, please lower the center of gravity of the vehicle as much as possible, extend the arm to the head, and insist that the bottom and slope of the bucket are 90 degrees to prevent the bottom of the excavatorfrom sliding into the excavator. The bottom.

4, sometimes you will encounter a loose arm climbing with the excavator, the excavatorcan slip, for this situation, the weight of the small excavator can be like this: dig the shovel as deep as possible, press the power, when the arm receives the head, do not spread it, let him tilt, small excavator, fireproof material moves down the track, the small excavatorforms a pile at the back of the track. Don't underestimate these little things. They'll make the excavators permanent. When left at the bottom of the bucket and excavator without sliding down, slowly move the arm to the head and it should be tied to the front. The deeper, the better.

Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

for more info just visit our website at www.dig-dog.com
contact # : +86 158 6218 2088
email : sales@bonovogroup.com